Drilling the bottom servo tab with #40 bit.
posted by Unknown at 2:16 AM
Sunday, April 29, 2007
Previous Posts
- Drillling the upper servo tab with #40 bit first.
- Lots of work had been done at this stage mainly po...
- The hinge was trimmed such that the first knuckles...
- The forward spar was inserted between the two aile...
- The outboard end rib was trimmed to 6.5" length wh...
- Similarly, 23" x 2-13/16" of material was cutteed ...
- Using my newly acquired digital Dremel 400 series ...
- Using my newly acquired Dremel tool (purchased fro...
- Duplication on the other inspection hole cover.
- The rivet holes of nutplate K1000-08 drilled compl...
0 Comments:
Post a Comment
<< Home