I am seen here drilling the spar holes with #40 bit.
posted by Unknown at 1:23 AM
Friday, April 06, 2007
Previous Posts
- With the assembly clamped upside-down on the bench...
- Note, i did not follow the manual strictly w/regs ...
- With two cellophone tapes with width of exactly 1/...
- Drilling the nose ribs and bracket with #30 bit.
- Outboard hinge bracket holes being drilled.
- Another hinge bracket being drilled. Note this inb...
- Mark and drill the inboard hinge bracket. Note..si...
- After all dimpling have been completed...
- The result ...
- Dimpling the ribs and nutplates in progress..
0 Comments:
Post a Comment
<< Home