Flap track guide arm in place and addditional 5 holes drilled using #30 bit and pilot holes.
posted by Unknown at 12:28 AM
Monday, September 10, 2007
Previous Posts
- All holes completely re-drilled at its 2 pre-punch...
- Drilling the two pre-punched rib web holes using 1...
- Note, all centreline markings have been done earli...
- Only 6 pairs of reinforcement angles required for ...
- Trial fitting the reinforcement angles onto its ma...
- Cutting and trimming the nose rib reinforcement ...
- Location: Dad's factory in Kuala LumpurPeriod: My ...
- Mission accomplished .
- Let the hand riveting begins...
- Here, I am seen drilling the trailing edge joggl...
0 Comments:
Post a Comment
<< Home