Mark locations for the inspection hole doubler rivet holes + center punch them.
posted by Unknown at 1:30 AM
Friday, April 06, 2007
Previous Posts
- Drilling the nose ribs with #30 bit except the hol...
- Tadaaah!!!...
- Here, i am seen drilling the aft rib holes with #3...
- Here, i am seen drilling the aft rib holes with #3...
- The end result after lots of drilling..
- I am seen here drilling the spar holes with #40 bit.
- With the assembly clamped upside-down on the bench...
- Note, i did not follow the manual strictly w/regs ...
- With two cellophone tapes with width of exactly 1/...
0 Comments:
Post a Comment
<< Home