Positioning and drilling the upper hinge line on the aileron with #40 bit first.
posted by Unknown at 1:38 AM
Monday, April 30, 2007
Previous Posts
- Drilling four holes on the servo horn through the ...
- Had not done my project for a while due to base ch...
- Drilling the bottom servo tab with #40 bit.
- Drillling the upper servo tab with #40 bit first.
- Lots of work had been done at this stage mainly po...
- The hinge was trimmed such that the first knuckles...
- The forward spar was inserted between the two aile...
- The outboard end rib was trimmed to 6.5" length wh...
- Similarly, 23" x 2-13/16" of material was cutteed ...
0 Comments:
Post a Comment
<< Home