The result...
posted by Unknown at 1:39 AM
Saturday, May 12, 2007
Previous Posts
- Hand rivet squeezing the outermost nose ribs.
- Finishing up blind riveting the lower nose ribs..
- With epoxy glue applied in between the servo tab t...
- Blind riveting the top servo skin to the spar with...
- Close up view of the inspection doubler in place.
- After riveting the lower servo tab to the spar .
- The trailing edge joggle is drilled with #40 bit w...
- Here, the inspection doublers are being riveted to...
- This is the second doubler riveted to the spar.
- Riveting the inspection doubler on the spar.
0 Comments:
Post a Comment
<< Home