Here, the rib/spar rivet holes were drilled with #30 bit. Shown: Rib Pair B.
posted by Unknown at 12:39 AM
Monday, September 10, 2007
Previous Posts
- Note, even the initial 2 index pre-punched holes w...
- Drilling additional 4 holes with #30 bit on the de...
- Flap track guide arm already drilled (Rib Pair B a...
- Flap track guide arm in place and addditional 5 ho...
- All holes completely re-drilled at its 2 pre-punch...
- Drilling the two pre-punched rib web holes using 1...
- Note, all centreline markings have been done earli...
- Only 6 pairs of reinforcement angles required for ...
- Trial fitting the reinforcement angles onto its ma...
- Cutting and trimming the nose rib reinforcement ...
0 Comments:
Post a Comment
<< Home