Duplicate the process for the other inspection hole.
Click the square for up close view of photo. 
Click the square for up close view of photo.
posted by Unknown at 1:31 AM
Friday, April 06, 2007
Previous Posts
- Mark locations for the inspection hole doubler riv...
- Drilling the nose ribs with #30 bit except the hol...
- Tadaaah!!!...
- Here, i am seen drilling the aft rib holes with #3...
- Here, i am seen drilling the aft rib holes with #3...
- The end result after lots of drilling..
- I am seen here drilling the spar holes with #40 bit.
- With the assembly clamped upside-down on the bench...
- Note, i did not follow the manual strictly w/regs ...
0 Comments:
Post a Comment
<< Home