The upper hinge line on the aileron were re-drilled with #30 bit.
posted by Unknown at 1:44 AM
Monday, April 30, 2007
Previous Posts
- The result after being re-drilled with #30 bit .
- Having marked 1.25" spacing on the lower hinge li...
- The upper hinge line fully drilled with #40 bit ho...
- Positioning and drilling the upper hinge line on t...
- Drilling four holes on the servo horn through the ...
- Had not done my project for a while due to base ch...
- Drilling the bottom servo tab with #40 bit.
- Drillling the upper servo tab with #40 bit first.
- Lots of work had been done at this stage mainly po...
0 Comments:
Post a Comment
<< Home