The completed servo tab with the horn 
in place.
in place.
posted by Unknown at 7:22 AM
Friday, May 25, 2007
Previous Posts
- Hand rivet squeezing the trailing edge of the serv...
- Close up view of the other outermost nose rib afte...
- The result...
- Hand rivet squeezing the outermost nose ribs.
- Finishing up blind riveting the lower nose ribs..
- With epoxy glue applied in between the servo tab t...
- Blind riveting the top servo skin to the spar with...
- Close up view of the inspection doubler in place.
- After riveting the lower servo tab to the spar .
- The trailing edge joggle is drilled with #40 bit w...
0 Comments:
Post a Comment
<< Home