Here, i am seen using an L-shaped straight edge to align the flap properly before drilling the aft spar using #40 drill bit.
posted by Unknown at 1:18 AM
Wednesday, December 02, 2009
Here, i am seen using an L-shaped straight edge to align the flap properly before drilling the aft spar using #40 drill bit.Previous Posts
- Result of drilling the main rib/nose rib and forwa...
- Here, i drilled the main rib of the starboard flap.
- Next, i drilled the nose /leading rib holes using ...
- 24 Nov 2009.It has been awhile since i last work...
- Yes, finally I have finished drilling one set of f...
- Last but not least, the trailing edge was drilled ...
- Note the limited clecoes in place though the rear ...
- The upper rear spar was being drilled finally.
- Driling the nose ribs with #30 bit except for the ...
- Done.
0 Comments:
Post a Comment
<< Home