Dimpling the relevant holes f
or the nutplates on the inspection hole doublers.
or the nutplates on the inspection hole doublers.
posted by Unknown at 1:47 AM
Monday, April 30, 2007
Previous Posts
- Likewise for the upper hinge line of the servo tab.
- The upper hinge line on the aileron were re-drille...
- The result after being re-drilled with #30 bit .
- Having marked 1.25" spacing on the lower hinge li...
- The upper hinge line fully drilled with #40 bit ho...
- Positioning and drilling the upper hinge line on t...
- Drilling four holes on the servo horn through the ...
- Had not done my project for a while due to base ch...
- Drilling the bottom servo tab with #40 bit.
0 Comments:
Post a Comment
<< Home